What Are The Reasons For The Computerized Flat Knitting Needle?

What are the reasons for the computerized flat knitting needle?

The computerized flat knitting machine is a double-needle latch needle and weft knitting machine. Its cam device is like a set of flat cams. The stitches of the knitting needle can enter the cam groove, move the cam, forcing the knitting needle to make a regular lifting movement in the needle groove of the needle plate, and through the movement of the needle hook and the needle tongue , The yarn can be knitted into knitted fabrics. How to solve the problem of computerized flat knitting needle analysis.

1. Triangle parts

   The causes and solutions are:

  (1) If the triangle component has cracks or breakage, if it is not serious, then it should be ground to make it straight and smooth. If it is serious, then it must be reconfigured.

   (2) Improper or improper fit between the triangular parts makes the gap between them too large. The solution is to adjust the triangular parts so that the gap is within the specified range. If not, reconfigure the parts.

  (3) After the triangular part is heat-treated, the hardness does not reach the specified standard. The solution is to re-heat the triangular part to make the hardness reach HRC58-62. If not, reconfigure the part.

   (4) The gap between the triangular part and the needle bed is too large. The solution is to put a triangular base plate underneath, and then adjust the gap to a value of 0.2-0.35mm.

  (5) The triangle movement area in the triangle part is too large or too small. The solution is to adjust the triangle movement area to make it suitable.

  (6) The triangle screw is loose. The solution is to reinforce it and tighten the triangle screw.

  (7) The length of the pressure needle cam is too short. The solution is to change the pressure needle cam to a suitable one.

  (8) The height of the thimble is too high, the solution is to adjust the height of the thimble.


  2, knitting needles

   The causes and solutions are:

  (1) If the hardness of the heat treatment is too large or too small, the solution is to replace the knitting needle with a suitable hardness.

  (2) After the needle butt is damaged, hairy or bending occurs. The solution is to replace the needle butt.


3. Machine head and guide rail

   The causes and solutions are:

   (1) The machine head and guide rails have been used for too long, making them wear very seriously. The solution is to trim the machine head and guide rails.

  (2) The screw is loose. The solution is to reinforce it and tighten the screw.


   4. Other aspects

   The causes and solutions are:

   (1) Due to the missing needles, the knitting needles fall down, resulting in a needle strike phenomenon. The solution is to find out the cause of the missing needles and then solve them.

  (2) The needle placement height is not enough, the solution is to adjust the needle placement height.

  (3) The quality of wool yarn is not good enough, the solution is to improve the quality of wool yarn.